That said, I've ordered a new DigiTrax EVOXD Evolution Express Advanced 5A/8A Duplex Starter Set to replace the DCS52. Once you have downloaded the JMRI software and installed it. The lower you go the further it jumps like a frog. How do I start the DecoderPro program for New User Back. 70 provided even faster READS, but makes the locomotive JUMP forward far too much on each READ. DecoderPro can run on any computer system that will run Java 1.6.0 or later, whether it is Macintosh, Windows, or Linux. DecoderPro3 is a Java-based cross-platform application for model railroaders. Online Help for the current version of JMRI DecoderPro is here. I replaced my DCS52 with a 52, but only after changing CV217 to 95 did things get better. A Presentation to Provide New Users with 1- an Introduction to JMRI (DecoderPro)2 - The screens (and the how to's) they will see while installing JMRI for th. This Manual deals with DP3 up to version 3.6. Then, if necessary try CV217=50, then CV217=20, then CV217=10 until you find the settings that are best for your particular set up.ĭifferent throttle manufacturers pulse the program track differently - so we cannot have a "one size fits all" setting by default." If the results are not good, set CV217=90 on the mainline, then move the loco to the program track and attempt to read/write CVs in Direct Mode and/or Paged Mode (if one doesn't work, try the other). I would start by setting CV217=110 on the mainline, then move the loco to the program track and attempt to read/write CVs in Direct Mode and/or Paged Mode (if one doesn't work, try the other). (optionally) Boot Loader allows firmware upgrades over LocoNet. Automatically saves status during power down. Full optical isolation between LocoNet and TC-64. Each port can be individually addressed, or as part of a group. The higher you set CV217, the less power is given to the motor while programming. JMRI DecoderPro 2.0 or later.) Both read and write of CV values is supported in OPs mode. That's why it's not an NMRA standard - it's a BLI thing only on Paragon3/Paragon4 N Scales. JMRI® can run on any computer system that will run Java 1.6.0 or later, whether it is Macintosh, Windows, or Linux based. Our engineer created CV217 to lessen the amount of power that was given to "chirp the motor" to overcome that obstacle. However, that design posed a problem with reading CV's sometimes and in some programming modes because when the energy was used to A) Charge the capacitors, and B) "chirp the motor" - the packet of data could not make it round trip back to the throttle. "When we designed this new N Scale decoder, we wanted to have a lot of capacitance to prevent pickup issues over frogs and such. I got a reply from BLI and they mentioned CV217 being set lower than the default of 110.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |